Assessment of the efficacy of six field cleaning protocols for hydrocarbon quantification.

The defensibility of field sampling data collected in support of natural resource damage assessments and other environmental investigations depends on rigorous quality assurance and control both in the field and laboratory. One important step in field procedures is the cleaning of sampling equipment between samples to minimize the carryover of contaminants. Large-scale sampling efforts during the Deepwater Horizon oil spill event have highlighted the importance of understanding how multiple equipment cleaning protocols affect interstation cross-contamination and the resulting chemical data quality. In this study, six field cleaning techniques were tested on metal sampling equipment using two different sediment types spiked with crude oil in order to understand their relative and absolute effectiveness in reducing chemical carryover. The complexity of the cleaning protocols ranged from a simple water and scrub brush application to protocols that included soap and/or solvent. In this study, percent residual hydrocarbon transfer, relative to total loading in sediments, never exceeded 0.032%. The least labor-intensive protocol, water and scrub brush application, had the highest potential for hydrocarbon transfer (0.011-0.032%). Statistical differences were observed among treatments, and it was found that protocols containing a solvent step were more effective than protocols without solvents. Depending on the data quality objectives, the differences may not be meaningful, and choosing a cleaning technique should be governed by health, safety, and environmental factors. The residual hydrocarbons measured after equipment cleanings for all techniques in this study were negligible when compared with other variables that occur during routine sampling and laboratory activities.

An assessment of nutrients and sedimentation in the St. Thomas East End Reserves, US Virgin Islands.

Nutrients and sedimentation were monitored for approximately 2 years at six sites in the St. Thomas East End Reserves (STEER), St. Thomas, USVI, as part of a NOAA project to develop an integrated environmental assessment. Concentrations of ammonium (NH4+) and dissolved inorganic nitrogen (DIN) were higher in Mangrove Lagoon and Benner Bay in the western portion of STEER than in the other sites further east (i.e., Cowpet Bay, Rotto Cay, St. James, and Little St. James). There was no correlation between rainfall and nutrient concentrations. Using a set of suggested nutrient thresholds that have been developed to indicate the potential for the overgrowth of algae on reefs, approximately 60% of the samples collected in STEER were above the threshold for orthophosphate (HPO4=), while 55% of samples were above the DIN threshold. Benner Bay had the highest sedimentation rate of any site monitored in STEER, including Mangrove Lagoon. There was also an east to west and a north to south gradient in sedimentation, indicative of higher sedimentation rates in the western, more populated areas surrounding STEER, and sites closer to the shore of the main island of St. Thomas. Although none of the sites had a mean or average sedimentation rate above a suggested sedimentation threshold, the mean sedimentation rate in Benner Bay was just below the threshold.

An assessment of butyltins and metals in sediment cores from the St. Thomas East End Reserves, USVI.

Tributyltin (TBT) concentrations near a marina complex in Benner Bay on St. Thomas, US Virgin Islands, were elevated relative to other areas in a larger study of the southeastern shore of the island. At the request of the USVI Coastal Zone Management Program, sediment cores and surface sediment samples were collected to better define the extent and history of TBT deposition in the vicinity of Benner Bay. The sediment cores were sectioned into 2-cm intervals and dated with 210Pb and 137Cs. The core sections and the surface samples were analyzed for butyltins and 16 elements. Deposition rates varied from 0.07-5.0 mm/year, and were highest in the marina complex. Core ages ranged from 54 to 200 years. The bottoms of the cores contained shell hash, but the top layers all consisted of much finer material. Surface concentrations of TBT exceeded 2000 ng Sn/g (dry weight) at two locations. At a depth of 8 cm TBT exceeded 8800 ng Sn/g in the marina complex sediment. Based on the ratio of tributyltin to total butyltins, it appears that the marina sediments are the source of contamination of the surrounding area. There is evidence that vessels from neighboring islands may also be a source of fresh TBT. Copper concentrations increase over time up to the present. Gradients of virtually all metals and metalloids extended away from the marina complex. NOAA sediment quality guidelines were exceeded for As, Pb, Cu, Zn, and Hg.

Baseline assessment of heavy metal concentrations in surficial sediment from Kachemak Bay, Alaska.

Heavy metal inputs to coastal Alaska ecosystems are driven by sediment loads from glacial meltwater and river outflows. This study characterized the spatial distribution of 16 major and trace metals in five strata in Kachemak Bay, as well as sediment total organic carbon content and grain size. Homer Harbor, a shallow harbor within the study area, contained elevated metal concentrations compared to the other strata. Outside the harbor, several metals, including Cr, Ni, Pb, and Zn, were significantly higher in the eastern strata than in the western portions of the bay. The opposite was true for a few other metals, such as Hg. However, most metal concentrations were below the National Oceanic and Atmospheric Administration's sediment quality guidelines for sediment toxicity to benthic communities.

An assessment of chemical contaminants in sediments from the St. Thomas East End Reserves, St. Thomas, USVI.

The St. Thomas East End Reserves or STEER is located on the southeastern end of the island of St. Thomas, USVI. The STEER contains extensive mangroves and seagrass beds, along with coral reefs, lagoons, and cays. Within the watershed, however, are a large active landfill, numerous marinas, resorts, various commercial activities, an EPA Superfund Site, and residential areas, all of which have the potential to contribute pollutants to the STEER. As part of a project to develop an integrated assessment for the STEER, 185 chemical contaminants were analyzed in sediments from 24 sites. Higher levels of chemical contaminants were found in Mangrove Lagoon and Benner Bay in the western portion of the study area. The concentrations of polychlorinated biphenyls (PCBs), dichlorodiphenyltrichloroethane (DDT), zinc, copper, lead, and mercury were above a NOAA Effects Range-Low (ERL) sediment quality guideline at one or more sites, indicating impacts may be present in more sensitive species or life stages. Copper at one site in Benner Bay was above a NOAA Effects Range-Median (ERM) guideline indicating effects on benthic organisms were likely. The antifoulant boat hull ingredient tributyltin (TBT) was found at the third highest concentration in the history of NOAA's National Status and Trends (NS&T) Program, which monitors the nation's coastal and estuarine waters for chemical contaminants and bioeffects. The results from this project will provide resource managers with key information needed to make effective decisions affecting coral reef ecosystem health and gauge the efficacy of restoration activities.

Characterization of organic chemical contaminants in sediments from Jobos Bay, Puerto Rico.

Jobos Bay, located on the southeastern coast of Puerto Rico, contains a variety of habitats including mangroves, seagrass meadows, and coral reefs. The watershed surrounding the bay includes a number of towns, agricultural areas, and the Jobos Bay National Estuarine Research Reserve (NERR). Jobos Bay and the surrounding watershed are part of a Conservation Effects Assessment Project (CEAP), involving the Jobos Bay NERR, the US Department of Agriculture, and the National Oceanic and Atmospheric Administration (NOAA) to assess the benefits of agricultural best management practices (BMPs) on the terrestrial and marine environments. As part of the Jobos Bay CEAP, NOAA collected sediment samples in May 2008 to characterize over 130 organic chemical contaminants. This paper presents the results of the organic contaminant analysis. The organic contaminants detected in the sediments included polycyclic aromatic hydrocarbons (PAHs), polychlorinated biphenyls, and the pesticide DDT. PAHs at one site in the inner bay near a boat yard were significantly elevated; however, all organic contaminant classes measured were below NOAA sediment quality guidelines that would have indicated that impacts were likely. The results of this work provide an important baseline assessment of the marine environment that will assist in understanding the benefits of implementing BMPs on water quality in Jobos Bay.

Characterization of land-based sources of pollution in Jobos Bay, Puerto Rico: status of heavy metal concentration in bed sediment.

As part of an assessment of land-based sources of pollution in Jobos Bay, Puerto Rico, sediment samples were collected at 43 sites to characterize concentrations of a suite of pollutants, including metals. Fifteen major and trace metals (Ag, Al, As, Cd, Cr, Cu, Fe, Hg, Mn Ni, Pb, Sb, Se, Sn, and Zn) were measured along with total organic carbon and grain size in surficial sediments. For most metals, maximum concentrations were seen in the eastern bay; however, values were still within concentration ranges found in other estuarine systems. In contrast, silver was higher in the western region. In general, metal distribution in the bay was positively correlated with grain size. Additionally, correlations between Al and other metals suggest natural sources for metals. The data presented here suggest that, although the Jobos Bay watershed contains both urban centers along with industrial and agricultural developments, anthropogenic inputs of metals may be negligible.

Assessment of coastal storm impacts on contaminant body burdens of oysters collected from the Gulf of Mexico.

This study evaluated changes in oyster tissue contaminant levels following North Atlantic tropical cyclones to determine if changes in contaminant concentrations were predictable. The basis for this study was analysis of coastal chemical contaminant data from the National Oceanic and Atmospheric Administration's (NOAA) National Status and Trends Mussel Watch Program and NOAA's National Weather Service storm track data. The tendency for contaminant (metals and organic compounds) body burdens to increase or decrease in oyster tissue after a storm was assessed using contingency and correspondence analyses. Post-storm contaminant levels in oysters revealed a consistent pattern of distribution, which could be described as follows: (1) most of the organic contaminants stay within their long-term concentration ranges, (2) very few organic contaminants decreased, and (3) metals overwhelmingly tend to increase.

Cadmium distribution in coastal sediments and mollusks of the US.

Cadmium (Cd) concentrations in the coastal United States were assessed using the National Status and Trends (NS&T) Mussel Watch dataset, which is based on the analysis of sediments and bivalves collected from 280 sites since 1986. Using the 1997 sediment data, Pearson correlation (r=0.44, p<0.0001) suggested that Cd distributions in sediment can, be to some extent, explained by the proximity of sites to population centers. The 2003 tissue data indicated that "high" Cd concentrations (greater than 5.6 microg/g dry weights [dw] for mussel and 5.4 microg/g dw for oysters) were related to salinity along the East and Gulf coasts. Along the West coast, however, these "high" sites appeared to be related to upwelling phenomenon. Additionally, sedimentary diagenesis was found to be the most likely explanation of why sediment and mollusk Cd content were not well correlated.